4-Channel L293D Motor Driver Shield Stepper Motor Driver for Arduino Mega 2560 and UNO R3

L293D is a monolithic integrated, high voltage, high current, 4-channel driver?you can use DC motors and power supplies of up to 36 Volts, the L293D chip is also known as a type of H-Bridge?which is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.

2 interface for 5V Servo connected to the Arduino’s high-resolution dedicated timer – no jitter.

Can drive 4 DC motors or 2 stepper motors or 2 Servo.

Up to 4 bi-directional DC motors with individual 8-bit speed selection.
Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.

4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 36V DC.
Pull down resistors keep motors disabled during power-up.

2 external terminal power interface, for separate logic/motor supplies.

Tested compatible for Arduino Mega, Uno, Diecimila & Duemilanove.
Reset button.